Magikitchn LPG-60 User Manual download pdf (Page 6)

L25-003 Rev 4 (09/12)

2. CHARBROILER ASSEMBLY and INSTALLATION

These unassembled parts should be included in your charbroiler package (Figure 1):

Item Number Description

1 Cooking Grid (s)

2 Radiants

6 Frame Assembly

8 Runner Tube Cover(s)

9 Water Tub(s)

10 Base

25 Leg & Swivel Lock Caster Assemblies

ASSEMBLY INSTRUCTIONS (Refer to Figures 1 & 10, and Table 1)

1. Remove shipping bands from carton.

2. Remove top of carton.

3. Remove cooking grids(s), (1) from unit and set aside.

4. Remove and unwrap any small parts packages that are located inside beneath the cooking grid. NOTE:

Parts made of stainless steel may be coated with a protective plastic film that must be removed before

firing.

5. Lift frame assembly (6) from carton and set aside.

6. Lift water tub(s) (9) from carton and set aside.

7. Lift base (10) from carton and place upside down on ground.

8. Go to Section 4 or 5, on page 6, and mount the side tank rack(s) to the base unit. Then return to step 9

below.

9. Flip the base over, with the leg & caster assemblies installed, into the upright position. On a 30” appliance,

the front of the base unit has the tank rack on the left side (See Figure 5).

10. Place the frame assembly (6) on base (10) with the shelf support brackets located in the notches on the

front base assembly.

11. Place runner tube cover(s) (8) on their brackets to cover the runner tube(s).

12. Place the radiants (2) on their front and rear support pins over each burner.

13. Slide water tub(s) (9) into frame assembly (6).

14. Place cooking grid(s) (1) into frame assembly (6).

1 2 3 4 5 6 7 8 9 10 11 ... 14 15

No comments

Magikitchn LPG-60 User Manual Page 6